OEM Inoxpa Pump Seal Replacement

Payment Type:L/C,T/T,D/P,D/A,Paypal,Money Gram,Western Union

Incoterm:FOB,CFR,CIF,EXW

Transportation:Ocean,Land,Air,Express

Port:shanghai,guangzhou,ningbo

Product Attributes
Supply Ability & Additional Information
Packaging & Delivery
Other information

Product Attributes

Brand: Enactus

Place Of Origin: China

Supply Ability & Additional Information

Packaging: Carton,outer package as request

Transportation: Ocean,Land,Air,Express

Place of Origin: China

Supply Ability: 1000000 Piece/Pieces per Month

Port: shanghai,guangzhou,ningbo

Payment Type: L/C,T/T,D/P,D/A,Paypal,Money Gram,Western Union

Incoterm: FOB,CFR,CIF,EXW

Packaging & Delivery

Selling Units:

Piece/Pieces

Package Type:

Carton,outer package as request

To replace the OEM Inoxpa Pump Seal, follow these steps:
1. Shut off the pump and disconnect the power supply to ensure safety.
2. Drain the pump and remove any remaining liquid from the system.
3. Remove the bolts or screws that secure the pump casing or cover in place. Carefully lift off the casing to expose the internal components.
4. Locate the existing seal assembly within the pump. This may be a single or double mechanical seal, depending on the specific model.
5. Take note of the orientation and position of the existing seal components for reference during reassembly.
6. Carefully remove the seal assembly from the pump. This may require loosening retaining screws or clips and gently prying the seal away from the shaft.
7. Clean the seal housing and shaft thoroughly to remove any debris or residue.
8. Install the new OEM Inoxpa pump seal by following the reverse procedure of the removal. Ensure that the seal is properly aligned and seated within the housing.
9. Apply a thin layer of lubricant or sealant to the seal components as recommended by the manufacturer.
10. Reassemble the pump by securing the casing or cover back in place using the appropriate bolts or screws.
11. Connect the power supply and turn on the pump to test its operation. Monitor for any leaks or abnormal noises.
12. If everything is functioning properly, close the pump and resume normal operation.
OEM Mechanical Seals :

INOXPA ® Prolac Pumps Series
INOXPA ® SLR Series LOBE ROTOR Pumps

Shaft size:

0.625 inch, 1.0 inch, 1.5 inch

Design:

O-ring mechanical seals
Multi-Spring Mechanical seals
Seat ring:

Carbon Carbide and Silicon Carbide
Ni-Resist Steel Seat, Viton O-Ring

sealed waste water lift pump